"
Supported by

Breakpoint in message from inside the debugger

You’re in the middle of a debug and want it to stop at a specific message.

What to do?

Press F9 to create a new break-point, choose the “Message” tab and there you’ll be able to specify the exact message id, number which should stop execution. You can even define the type of message (error, warning, etc.). That’s it.

debug-message

While you’re there take a look at the other tabs to see what else you can do there.

Thanks Hamid Kharoune for the tip.
Thanks airdiogo for the photo.

Greetings from Abapinho.

Um comentário a “Breakpoint in message from inside the debugger”

  1. Vinícius Diz:

    Excelente!

Deixe um comentário


About Abapinho
Abapinho runs on WordPress
Articles (RSS) e Comments (RSS).